How To Change Dash Lights In A 2006 Gmc

The dashboard lights on your Chevy Silverado allow you to monitor your speed, fuel levels, temperature and other important information regardless of whether yous drive during the day or at nighttime. These lights can burn out, so here are the instructions for changing the lights on your dashboard.

1. Turn your truck ON and turn the lights ON.
2. Check the dashboard for lights. If y'all have dark areas on the instruments, you accept a lite that is out.
3. Set up the parking brake and set the cardinal to RUN. Shift into Low gear. This volition give you room to work.
4. Utilise a panel tool and remove the dashboard bezel. It pops right out from the fasteners.
5. The gauge is held on with four 7mm screws. Remove them using a socket with an extension.
6. One time you accept removed the screws, yous will be able to tilt the instrument cluster away from the opening. Tilt it on its side in society to get to the connection wires.
7. Squeeze the connectors together in guild to undo them from the cluster.
8. There are clips on the side of the gauge panel. Use a small flathead screwdriver to release them in order to get the front and the back panels off.
9. Use your finger and put all the gauges into their full, counterclockwise, locked position. Put pieces of clear tape under the dials and mark where the ends of the dials are located.
10. Use a dinner fork with a slice of record on the back of it under the dials and pry them upwards in order to remove them.
11. The lights are easily removed using a soldering iron by touching the leads on each side of the bulbs.
12. Use the old bulb as a template in society to determine the correct length for the legs on the new bulbs. Trim to the correct size.
13. Place the new bulb into the blue base.
14. Solder the new bulb into place.
15. Remove the plastic comprehend to the gauge set and put the set dorsum in to make sure that the bulbs are all working before you reinstall the gauge ready.
16. Reattach the dials and line them back up with the marks y'all made on the clear tape. The dials may need to be turned all the way to the right showtime.
17. Snap the front and the back panels together. Your cluster is at present ready to be put back into your Silverado.
18. Reattach your bezel.

You should have no trouble irresolute the lights in your Silverado, only if you do, you may need to contact your local dealership for farther help.

How To Change Dash Lights In A 2006 Gmc,

Source: https://www.newgmparts.com/how-to-replace-chevy-silverado-dashboard-lights

Posted by: negronwentiont.blogspot.com

Share this post